Originally Posted by
J Miller
For the cabinet leaves
Remove the screws from the leaf(s) and the cabinet body. Clean the holes.
Make sure the hinges are not bent. If so straighten them.
Then roll up some thin veneer or if you don't have any, match sticks and fill the screw holes mostly up. Before you put the veneer or match sticks in fill the hole with wood glue. After filling the hole slice off the filler wood at the surface.
After the hole is mostly filled and before the glue is dry reassemble the hinges to the cabinet body and leaf(s) and tighten the screws down tight.
I've done this to several cabinets and so far it's leveled up the leafs on all of them.
Joe
I must have misunderstood. I thought the leaf of the cabinet fit flush, that it was the left and right ends of the machine bed that was too high, creating a bump. If the machine head does not fit flush, could it be that it is the wrong cabinet for this machine?
Good Son to be thinking of what you would like.