Word of warning/advice to usint the Stretch and Seal. When I first heard of this I thought I had found the ultimate answer. Clear, stays in place, cheap. Drew design on the S&S with permanent Sharpie, applied it to the quilt top and stitched. All was well UNTIL I started to remove it. It is very difficult to get it out of small areas and the black ink on the plastic wrap was still there, showing up with the stitching. It didn't come off onto the fabric but the plastic bits were under the thread. ARRRRGGGHHH. If I tried it again, I would draw on it with Frixion pens and possibly not use anything very intricate. Know that bits will remain for some time. Anyone with any suggestions to success with this - would love to hear from you.