Guess I just need to read a little better, but I do agree with you about possibly using freezer paper and opting out of this method. I find if you print the design onto copy paper then take a 2nd piece of copy paper and to that sheet iron a larger piece of freezer paper to its surface. Carefully trim it to the correct size and check to be sure the feed edge of the sandwiched papers are well fused and then run it through your printer. You peal away the two sheets...and yes the freezer paper is a slight bit less "sticky" and you cannot use it as many times as you might if you traced it...but it is a LOT easier than tracing over and over. I also understand why you might give this a try...as they say: "nothing ventured nothing gained!"