18-Degree Squedge Table Topper
[ATTACH=CONFIG]546787[/ATTACH]
I have made square Squedge blocks before, but this was a first. This is birthed not bound. It was supposed to have 8 points. You could say I made a design decision or that I wasn't paying attention when I picked up the wrong squedge, but I like the 10 points better. That is my story and I am sticking to it. I tried to use stack and whack but it isn't possible for them to be identical because the border print was asymmetrical and the squedge has to be flipped for half the points so this is as close as I could get. Flipped it and then appliqued the circle on and a quick quilting job of following the lines. Pretty quickly done. Have a great week.