yes, I did use the small rotary.and the odd shaped template is well made...it has the cuts into the template at the intersection to allow for the cross cut, and after doing two - three layer cuts, I remembered how to hold the cutter to get the clean cut....
I was disappointed, and I wish I could have just purchased the one die from the set but accuquilt said "no" whole Qube had to be purchased and I was not about to "invest". The tricky part ( after doing one wrong -and redoing after I figured it out) was placing that little triangle between the two pointed wedges in just the right spot...I did not have any instructions..just watching the short promo about the Qube.....but I did figure it out, and after this wonderful holiday weekend, I will go back to my world, cut out enough for a table runner and show here when done.....if I did have the die, I might consider something larger.
Onebyone----- you are very fortunate to belong to a guild that is so up to date and Using/ sharing dies and cutters. I brought that possibility up to the guild here last year and got "deer in the headlines". So I am alone in this venture, but i can and will do this.