So I finally got to visit jpwewst and pick up the little gunnybear. After visiting a bit I knew it was going to be interesting. I could see where a lot of cleaning and oiling had been done. Found these odd screws holding down the top/faceplate assembly.[ATTACH=CONFIG]584422[/ATTACH]
Yes, they are oil holes and screws too. Interesting. I got out my long spout oiler and kept it busy as I hand turned it. It was indeed sluggish I got the LCR needle positioner to move, YAY, and another piece to turn that I don't know what it should do yet. Some controls are still stuck, but it freed up in spinning. I hooked power to the motor and it is now turning pretty well. Now to try to get more controls free and find a bobbin case and bobbin. oh yea, and a needle. Thank jpwest.[ATTACH=CONFIG]584423[/ATTACH] We had a nice visit. 3 machines left her house and she found out I know some of her in laws.