Tips to FMQ with metallic thread?
I am using a 90/14 Topstitch needle with Gutermann metallic thread. 0 stitch length, FMQ foot #29, top tension lowered to 2, feed dogs down. My machine is flush to table with Supreme Slider. And I use Machinegers.
But ... thread sometimes is too loose on the back and forms nests, especially at quilting intersections. I have a solid white cotton back, W&N batting, and a Christmas print front. Fabric is very basic cotton from JAF. There is no piecing. It’s a whole cloth that I will later sub cut into coasters.
I usually only quilt with cotton or silk thread. Are there any tricks to working with poly? Any tricks to working with such a thick thread other than switching to a basic cotton in either the top or bobbin? I really like the look when it turns out. I did figure out the only way to start/end is with microstitches because it’s too thick to tie & bury.
All ideas are appreciated! I’m trying to finish this tonight!