Originally Posted by
Maggie8801
could you post a picture of golf tee/embroidery thread hold. Mind has gone blank.
Maggie, Not sure if you were asking me about storage but I will reply. Measure the drawer space. I use Elfa wire rack systems with single height baskets. The inside measurements are approx 18x 18.
https://www.containerstore.com/s/elf...uctId=10014851
H0me dep0t will cut the dry erase board to your measurements. Use a sharpie marker and start one inch in from edge. Mark dots 3 inches apart in a grid on the whole board. Just a light dot with the sharpie will do. Glue golf tees onto the board. I use hot glue g*un. Golf tees purchased are 2 3/4 inches and already painted white. Each of the boards (18x18) hold 81 spools of EMB thread (Exquisite, Floriani and brother). I did 5 drawers like this and it keeps the threads from shifting in the drawers.
You can adjust the spacing of the golf tees as needed depending on thread spools. Someday, I will arrange the serger threads in a similar method.
Hope that helps!