Thank you for all of your kind and encouraging posts. It is the Binding Tool Star quilt pattern from MissouriStarQuiltCompany (MSQC). Having said that, I have had problems (all of them mine) with this pattern. 1) I used a binding tool that was 8 3/8 long (MSQC binding tool is 8 1/2" long). Had to cut my square piece down to fit my strip pieces. No problem. 2) The hypotenuse of my 1/2 square triangles were not long enough. I recut my squares so that the angles would fit my pieces. 3) The first 4 blocks turned out beautiful and I thought I was doing fine. However, when I finished my 5th block and put it up on my design wall, the triangles are too large and the pattern does not fit correctly. 4) I (finally) measured the width of my strips and found that they are 2 5/8 inches wide rather than 2 1/2. This, I believe, is why the correct 1/2 square triangles were too short.
I love this pattern and am determined to finish this quilt. My fix is to finish the blocks, sew them together and then add bias tape (made from the navy blue fabric) and sew it along the 1/2 square triangles. As shown in the photo below.
[ATTACH=CONFIG]602059[/ATTACH]
Last edited by yolajean; 10-04-2018 at 01:41 PM.