View Single Post
Old 07-15-2022, 05:17 PM
  #3  
Rhonda K
Super Member
 
Join Date: May 2017
Location: Sunny Florida
Posts: 4,221
Default

Take the needle out and replace with a new needle.

Even if you have just put in a new needle, change it. The needle could be bent.

I took the plates off my machine and you are right about the needle position. The needle should be forward a twitch.

Before adding a new needle, turn the machine on and off. Are you in a decorative stitch or zig-zag stitch?

Be sure the needle is seated all the way up into the shaft and then tighten. The needle may have slipped down.

After that, the machine may need a service check.

Good luck and please let us know what happens.
Rhonda K is offline