went back and tried again it's not as crooked as it was before but still not "square" here are a few more pictures
Thanks for the feed back. open to more information or tips. Not sure if I should send it back. Figured if it fit low shank machine it would screw on and be good to go. I did purchase the metal area that screws on because I had read where the plastic ones tend to be tightened to tight and can break.
walking foot diff angles
[ATTACH=CONFIG]30968[/ATTACH]
walking foot diff angles
[ATTACH=CONFIG]30969[/ATTACH]
walking foot diff angles
[ATTACH=CONFIG]31207[/ATTACH]