Originally Posted by MadQuilter
Hey Rhonda, I have a question about cutting the square out of the center. It looks like you butt them up against each other - so how do you keep the rotary cutter from overshooting the corner? (Hope that makes sense.) If you cut past the corner and don't maintain the same angle, then you will lose part of the next piece.
Mad for myself I use a wider strip but I wanted to keep the waste down for everyone. I just do it carefully on the corners and don't go any farther than I have to. About a 1/4" from the corner or less and you should do ok. You can always pull the square up and out and run the blade over the bit of fabric still connected.