Shank Button
#3
Originally Posted by quilticing
Sew through the shank. If you've cut it off, you'll have to drill two small holes.
#4
Super Member
Join Date: Sep 2010
Location: North Texas
Posts: 1,283
Put a safety pin through the piece where you want to sew on the button, push the needle up then slide it through the shank and put it back through the material to the back. Push back up across the safety pin, put through the shank and down on the other side. Do this until it is well attached then tie off on the back side and undo and slide out the safety pin. Hope this helps.
mltquilt
mltquilt
Thread
Thread Starter
Forum
Replies
Last Post
klaws
Member Swaps and Round/Row Robins
133
11-01-2017 04:10 PM