Ric Rac roses
#5
I got these instructions from the www.wright.com website.
FULL BLOOM ROSE
You'll need:
1 yd. Wrights® Jumbo Rick Rack
To Make:
1.Fold Rick Rack to half length.
2.Interlock by hooking "Vs" together.
3.Pin to mark half the length. Fold raw end in and roll on itself up to pin. Remove pin.
4.Tack end and underside to hold shape; do not end off.
5.With same thread, stitch in one point and out the next point along lower edge Rick Rack.
6.Coil gathered points around rose base twice and tack to underside
FULL BLOOM ROSE
You'll need:
1 yd. Wrights® Jumbo Rick Rack
To Make:
1.Fold Rick Rack to half length.
2.Interlock by hooking "Vs" together.
3.Pin to mark half the length. Fold raw end in and roll on itself up to pin. Remove pin.
4.Tack end and underside to hold shape; do not end off.
5.With same thread, stitch in one point and out the next point along lower edge Rick Rack.
6.Coil gathered points around rose base twice and tack to underside
No. 2 - Interlock the Vs together
[ATTACH=CONFIG]158077[/ATTACH]
No. 3 - Pin and roll end
[ATTACH=CONFIG]158299[/ATTACH]
No. 5 & 6 - Roll and stitch
[ATTACH=CONFIG]158419[/ATTACH]
Thread
Thread Starter
Forum
Replies
Last Post
sunnyhope
Main
17
09-23-2009 04:41 PM