|
BMP6 issues
Top thread is clumping under needle plate 😬. Any suggestions?
|
are you using the correct size bobbin?
is it wound nice and tight? is it loaded correctly? |
They are pre-wound and I bought this machine new and have had it for years. Always stitched beautifully until a few days ago! I’ve taken it apart and cleaned it. Swapped bobbins and top thread. I’m baffled. Sent msg to baby lock but no one has responded. Unfortunately, the retailer I purchased from and authorized dealer that serviced it closed their doors after 2020. 😞
|
When a regular sewing machine has this type of problem, it is usually the thread in the bobbin. A small piece of thread can cause a big thread problem. I Googled it and found this answer in a Ricoma website, but I suspect it will apply to your machine too.
https://ricoma.zendesk.com/hc/en-us/...0direction.%29 Brother has this to say: https://www.brother-usa.com/blogs/st...h-these-4-tips Good luck! When this happens, it frustrates all of us badly. fyi....this was my search parameter: upper thead causing a bird's nest in the bobbin area of a large embroidery machine |
Thank you. Will take apart again! It only happens when project are a mile high with a deadline.
|
| All times are GMT -8. The time now is 11:15 AM. |