Alto's Quilt Cut 2
#22
Super Member
Join Date: Aug 2010
Location: Jacksonville, FL
Posts: 1,389
Thank you for the lefty info. I've grown weary of using things 'upside down' for left handers. While many manufacturers have jumped on the bandwagon with numbering for both, many of the 'specialty' templates are still not lefty friendly.
#23
You are very welcome. I am also keeping the box it came in - stash it behind a sofa in my sewing room so if I need to put the Alto away to drop the table so I can pin a top to batting etc. I can.
The sofa is a sofabed queen size, I use foam board from Joann's as a hard area to place the backing etc on to pin.
Then when done, fold bed back into sofa, and bring out my cutting table etc. again.
The sofa is a sofabed queen size, I use foam board from Joann's as a hard area to place the backing etc on to pin.
Then when done, fold bed back into sofa, and bring out my cutting table etc. again.
#26
Power Poster
Join Date: Dec 2008
Location: Western Wisconsin
Posts: 12,930
I thought of one advantage of the Go! I haven't seen mentioned elsewhere. That is, it is completely safe to use -- no danger of slipping and cutting your hand, or of dropping a rotary cutter. Have seen an occasional horror story posting of that happening to people. For this reason a Go! would be safer to use with children and for anyone who might be a little clumsy from a medical condition.
#27
Left-handed usage - It is very easy to change from right to left, you just place the ruler on the other side in its trench. Works the same way. My sister is a lefty and she uses it too.
The safety is not a huge issue because when you are holding the ruler with one hand and cutting with the other, your holding hand is actually about 1/2" ABOVE the cutting surface. Much safer than trying to hold the ruler and cut. Of course, if you are like me, you can still find a way to get cut -- been there, done that, had the stitches to prove it.
The safety is not a huge issue because when you are holding the ruler with one hand and cutting with the other, your holding hand is actually about 1/2" ABOVE the cutting surface. Much safer than trying to hold the ruler and cut. Of course, if you are like me, you can still find a way to get cut -- been there, done that, had the stitches to prove it.
#29
Senior Member
Join Date: Jul 2010
Location: Ohio
Posts: 390
Originally Posted by DebsShelties
Originally Posted by katied772
How many thicknesses can you cut through?
#30
I don't understand why it's still the notion that the die cut machines have so much waste. Not true. I have strings of fabric left, not much to do anything with. I have the Go and the Alto Cut2. I would give up the Alto in a second if I had to choose. I seldom get the same accurate cut twice using the Alto, it's always a smidgen off. It's me I know but that's what I don't like, not being able to cut perfectly every time. If the guide is not in the precise place as it was on the cut before it, the cut is off.
Thread
Thread Starter
Forum
Replies
Last Post