Go Back  Quiltingboard Forums > Main
Conserving Fabric While Cutting - Tips? >

Conserving Fabric While Cutting - Tips?

Conserving Fabric While Cutting - Tips?

Old 08-01-2020, 07:56 AM
  #1  
Super Member
Thread Starter
 
Join Date: Sep 2011
Location: Mendocino Coast, CA
Posts: 4,848
Default Conserving Fabric While Cutting - Tips?

Fabric is so expensive these days! I remember, not that long ago, I could get high quality, cotton, quilting fabric on sale for only $2.99/yard. Now, I'm lucky to find it at $5/yard and regular prices are way beyond my budget. I'm careful with every cut I make, so as to not waste any fabric unnecessarily. How do you make the most of the fabric while you are cutting pieces?

My tips:

-When cutting off chunks of fabric from a larger piece, I always measure first, so that I get just the right amount to make up a certain number of squares/pieces out of the piece.
-I always start cutting a folded strip of fabric from the unfolded edge and continue to cut towards the folded edge, so that if I have any leftovers at the end of the strip, there is a greater chance that I'll have some usable pieces left, once they are unfolded.
- I always trim off the selvedge first, so that I don't find it surprisingly in one of my squares, which I would then have to throw away.

~ C
tropit is offline  
Old 08-01-2020, 08:23 AM
  #2  
Super Member
 
Join Date: Nov 2011
Location: Tn
Posts: 8,712
Default

When cutting various sizes try to cut the largest pieces first. Excess fabric from those strips can be used for smaller squares/strips
cjsews is offline  
Old 08-01-2020, 09:35 AM
  #3  
Super Member
 
Join Date: Sep 2019
Location: North Idaho
Posts: 1,687
Default

I have learned to fall in love with crumb quilting. it's a great way to use up all those small pieces you just can't stand to throw away
LAF2019 is offline  
Old 08-01-2020, 09:51 AM
  #4  
Super Member
 
juliasb's Avatar
 
Join Date: Jun 2010
Location: Waterford Michigan
Posts: 7,241
Default

The first thing I do is make sure every piece is straight! I have less waste that way especially with strips where you can end up with humps that cannot be used. I cut my pieces as close to each other as possible. Now with my Accuquilt I am finding I have less waste. Those little pieces are are cut into pieces to be used with another DWR quilt and the pieces that are even smaller than that are now being collected for an animal rescue to make bedding for the animals. The larger pieces end up in my scrap baskets for future scrappy quilts. Nothing is wasted.
juliasb is offline  
Old 08-01-2020, 10:38 AM
  #5  
Power Poster
 
RedGarnet222's Avatar
 
Join Date: Jan 2009
Location: Reno, Nv
Posts: 16,521
Default

A couple times I have cut the wrong size strip and had to re-cut. Praying that I have enough. I would say engage your total focus while cutting and that way you won't waste any precious fabric.
RedGarnet222 is offline  
Old 08-01-2020, 10:43 AM
  #6  
Super Member
 
Join Date: Jan 2011
Location: Cottage Grove, MN
Posts: 2,807
Default

If the strips are 1.5” or wider, I will sometimes sew them together to make bigger pieces of fabric.
retiredteacher09 is offline  
Old 08-01-2020, 11:29 AM
  #7  
Super Member
 
Watson's Avatar
 
Join Date: Dec 2015
Location: Ontario, Canada
Posts: 4,349
Default

If you need width of fabric strips for something and think you may need to buy more material for a project, check your fat quarters first. You can often cut strips and sew them together end to end to make a strip long enough and it won't ever matter that there is a little seam in there and you can often cut around it anyway, if you are sub-cutting the long strip.

Watson

Watson is offline  
Old 08-01-2020, 11:39 AM
  #8  
Power Poster
 
Join Date: May 2008
Location: MN
Posts: 24,400
Default

I've seen older blocks that the pieces were pieced.

I do not like to do that - but if that's the only way to eke out a block - i will do that.

For conserving fabric - before buying it - I try to remember to check to see if it has been pulled off-grain. I really have to be in love with the fabric to buy off-grain fabric. If it is a print - has it been printed on-grain? Sometimes it has been printed on-grain, and been pulled off-grain. That can be straightened. If it has been printed off-grain - it is off-grain. Deal with it - or not.

I do "assume" about two inches of shrinkage per yard of fabric - I am not sure if it will be lengthwise or crosswise, but many fabrics have shrunk about that much. So - even though I am not "saving" by buying a couple of inches extra, I am building in "enough" - assuming the pattern is correct and I don't mess up.

If I actually know what I am going to be doing, I try to lay the fabric out and "survey" it before starting to cut - especially if working with something that needs to be fussy cut or is directional or has big pieces.

Maybe for me, the biggest "conserving" is to plan ahead - at least as well as I am able to.
bearisgray is online now  
Old 08-01-2020, 12:02 PM
  #9  
Power Poster
 
Jingle's Avatar
 
Join Date: Dec 2009
Location: Outside St. Louis
Posts: 38,190
Default

Originally Posted by tropit View Post

My tips:

-When cutting off chunks of fabric from a larger piece, I always measure first, so that I get just the right amount to make up a certain number of squares/pieces out of the piece.
-I always start cutting a folded strip of fabric from the unfolded edge and continue to cut towards the folded edge, so that if I have any leftovers at the end of the strip, there is a greater chance that I'll have some usable pieces left, once they are unfolded.
- I always trim off the selvedge first, so that I don't find it surprisingly in one of my squares, which I would then have to throw away.

~ C
I do this too. I don't buy expensive fabrics, nor do I use old clothes.
Jingle is offline  
Old 08-01-2020, 03:52 PM
  #10  
Super Member
 
Krisb's Avatar
 
Join Date: Aug 2011
Location: Asheville, previously Lake Vermilion, Tarpon Springs, Duluth, St Paul, Soudan
Posts: 1,651
Default

I have been known to use wide backing fabric to cut pieces. And the edges that are trimmed from the backing. And scrappy binding. And piece the back.

With an extensive stash, I seldom buy fabric any more. I did buy some Tula Pink for my Tula Pink, but it was on sale.

Last edited by Krisb; 08-01-2020 at 03:55 PM.
Krisb is offline  

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On
Trackbacks are Off
Pingbacks are Off
Refbacks are Off


FREE Quilting Newsletter