Diagonal Joins
#1
Diagonal Joins
I'm binding a wall hanging I made out of leftovers from a square patchwork duvet cover and I must say, trying to get good-looking diagonal joins on the binding strips about drove me out of my ever-loving gourd! Usually I just join straight edges and deal with the raised seam but this time I told myself we were going with the gold standard for this binding, and then I slowly and cursedly fell into the seam-ripping abyss.
What is it about this seam I just can't seem to master? One corner or the other is always off just enough to keep the two strips from lying straight and flat, even drawing a chalk line didn't help. The little ends wants to fray after so many unsews and then my nerves fray right along with them - is there a secret handshake club I must join to get the skinny? A ring I have to kiss? A favorite hairstyle that must be sacrificed? Help a quilty sister out, what's the secret to a nice and neat diagonal join?
Forever in your debt, ye who know much more than I...
What is it about this seam I just can't seem to master? One corner or the other is always off just enough to keep the two strips from lying straight and flat, even drawing a chalk line didn't help. The little ends wants to fray after so many unsews and then my nerves fray right along with them - is there a secret handshake club I must join to get the skinny? A ring I have to kiss? A favorite hairstyle that must be sacrificed? Help a quilty sister out, what's the secret to a nice and neat diagonal join?
Forever in your debt, ye who know much more than I...
#2
When I lay the fabric strips I overlap just a tiny bit and put my needle down and set the needle in the exact point of "V" and sew slowly so the needle comes out at the exact point of "V" on the opposite side.
#3
Glue baste! When I prep my strips, I fold and press one end to a 45 angle (the same one on each). Then I glue baste it, press it, pin it to be sure it doesn't shift. My vision isn't the best, so I often draw a chalk line on the fold line so I can see it better. Then I sew it, gently tug it to release the glue, and after that I trim it to 1/4" seam. I press those seams open. I fold/press the binding in half and attach it to the quilt starting about 6-8" from the first folded end.
I basically finish the last join the same way. I unfold the first end, overlap it on top of the remaining strip, draw a line where the folded one ends. Then I measure over 2-1/2" (or whatever your starting width) overlap and draw a line. Once I double check it, then I cut and glue baste that last seam.
I basically finish the last join the same way. I unfold the first end, overlap it on top of the remaining strip, draw a line where the folded one ends. Then I measure over 2-1/2" (or whatever your starting width) overlap and draw a line. Once I double check it, then I cut and glue baste that last seam.
#4
Power Poster
Join Date: Mar 2011
Location: Ontario, Canada
Posts: 41,467
I usually cross my strips with a little extra on each end. That lets me sew from V valley to valley for a nice join. I also have a piece of painters tape on the bed of my machine with a straight line drawn on with a sharpie. If I keep the little V valley on the line opposite from the needle, I can sew a straight join without marking.
Thread
Thread Starter
Forum
Replies
Last Post
oldsewnsew
For Vintage & Antique Machine Enthusiasts
20
07-17-2014 06:05 AM
Windblown
For Vintage & Antique Machine Enthusiasts
12
06-14-2013 02:04 PM
litacats
General Chit-Chat (non-quilting talk)
3
04-03-2011 11:01 AM
craftybear
Links and Resources
1
06-16-2010 11:49 PM