That pesky 1/4"
#1
That pesky 1/4"
OK, I have a question. I understand that we're supposed to use a scant 1/4" which works fine if you just sew two pieces of fabric together and iron the seam to one side. Ironing to one side uses up the scant part. However, what do you do when one seam crosses another causing some bulk? If you iron the whole thing to one side, the bulky part takes up more than a scant so part of the seam uses up the scant and the bulky part uses up more than a scant causing things to look wonky. I've tried using a hammer to flatten the bulk, sometimes it works, sometimes not. I've tried not sewing into the seam but that doesn't help the fact that two lines of stitching are crossing each other causing the bulk.
I hope I've explained this clearly. Am I trying to be too perfect? Thanks so much!
I hope I've explained this clearly. Am I trying to be too perfect? Thanks so much!
#4
I press open on lots of seams like pinwheels and 'm doing carpenter blocks for a quilt and I'm pressing them all open so they will lay flat. I try to be perfect too but I don't make quilts for show either mine are all made to be used and loved!!
#6
I guess I don't over-think it. I sew on the same machine, using the same guide for my seam width. There is then consistency thru-out the quilt. If I had several layers of fabric, I would be pressing seams open, too. It reduces the bulk.
#8
Banned
Join Date: Mar 2010
Location: Sturbridge, Ma
Posts: 3,992
Yes the bulky seams do cause a problem in making the blocks fit. I believe you have to press in such a way and join to give the least bulk at these junctions. Also, fabric weight and thread weight can make a difference. This is why it is always a good idea to make a small practice sample and then adjust according to the nature of the fabric and thread. I find that heavier weight - even #50 can cause more space to be taken up. Even one eight in bobbin and the other in top can give problems. One has to experiment.
I tend to grab any thread handy when thread runs out and if it takes up more space then switch back etc etc etc.
There is no sure way - need to experiement. Then, if I do have a bulk problem, I may shave a bit of one seam allowance to reduce the bulk.
I tend to grab any thread handy when thread runs out and if it takes up more space then switch back etc etc etc.
There is no sure way - need to experiement. Then, if I do have a bulk problem, I may shave a bit of one seam allowance to reduce the bulk.
#9
Power Poster
Join Date: Feb 2009
Location: Northern Michigan
Posts: 12,861
if you 'nest' your seams they do not build up- turn one one way the next the other way- & nest them side by side. alternate rows, so seams are pressed in one direction for one row- the opposite direction for the next row- and nest them as you join them. i've heard of beating seams with a hammer-but doesn't that break down the fibers??? an awful lot of work- to just destroy the integrity of the fabric--(just my thoughts)
Thread
Thread Starter
Forum
Replies
Last Post
bearisgray
General Chit-Chat (non-quilting talk)
65
02-01-2024 09:04 AM
Charlee
For Vintage & Antique Machine Enthusiasts
6
07-26-2012 10:05 AM
emsgranny
General Chit-Chat (non-quilting talk)
31
11-14-2010 03:45 AM