HEY EQ5 Users!!! I need EQ5 help with printing just the rotary cutting....
#1
Super Member
Thread Starter
Join Date: Jul 2008
Location: Maple Grove, MN (by way of GA, NC, PA, NC, AL!)
Posts: 1,548
....directions for a border. I did the border for Elle's IRR quilt in EQ5 and all it is letting me print is the fabric requirements, which I don't need, but I need the rotary cutting directions which I can't seem to figure out how to do!! Do I have to have a block in center (which is currently blank since I am just designing a border) in order for it to print the rotary cutting directions??
Thanks!!!!!
Thanks!!!!!
#3
Super Member
Thread Starter
Join Date: Jul 2008
Location: Maple Grove, MN (by way of GA, NC, PA, NC, AL!)
Posts: 1,548
Here is the project file (Elle, don't look) - not the real fabrics I'm using, just place holders to see if they colors work right.
I also left a post on the EQ website so hopefully I will hear from them too!
Thanks everyone!!!
I also left a post on the EQ website so hopefully I will hear from them too!
Thanks everyone!!!
#4
Hmmm...can't seem to get it either. did you see this topic
http://doyoueq.com/phpBB3/viewtopic.php?f=4&t=612
http://doyoueq.com/phpBB3/viewtopic.php?f=4&t=612
#5
Super Member
Thread Starter
Join Date: Jul 2008
Location: Maple Grove, MN (by way of GA, NC, PA, NC, AL!)
Posts: 1,548
i had not seen that post...so I may have to make 6 different 2-strip strip quilts the length of those borders and use the border design and print them out that way.
Or, I could be "old fashioned" and get out my ruler and figure it out myself....NAH!
thanks, thimble, for your help and research at the EQ site!
Or, I could be "old fashioned" and get out my ruler and figure it out myself....NAH!
thanks, thimble, for your help and research at the EQ site!
Thread
Thread Starter
Forum
Replies
Last Post