Janome 7700 dual feed help
#11
Thank you ladies. I know now that I am just doing something wrong as most of you wonderful ladies have advised me that you use your dual feed foot on your Janome with zigzag and decorative stitches. I am going to adjust my dial on the front and see if that helps. My dual feed foot is attached as I brought it down and it clicked into place. It will work if I want a straight stitch. I just cannot figure out how to make it move to the right side for the wide stitching and zigzag. I have broken needles attempting to do this before.
#14
I would have expected it to sew stitch #9 with the dual feed. I'm sure I have in the past. I have used the blanket stitches with mine so that wouldn't really be any different. I hope you get it sorted. If I'm unsure if I'm going to break a needle I always turn the wheel by hand to make sure I'm not going to hit anything. The dual feed should be fine though as it's built for the 7mm stitches
#15
Ladies, you all are so wonderful. I haven't ever met a more loving and helpful group. I just wanted to let you know that I finally found out what I was doing wrong when I could not get my Janome to zigzag when using my walking foot. Turns out a couple of years ago, I ordered a walking foot to fit my Janome with a 1/4 inch guide on it. When I received it,it measured 1/3 inch instead. So I never did used it. That was the foot I had on the machine. It would not zigzag with it either. I put the walking foot on that came with the machine. It worked perfectly after I had lost my mind. Thank you all greatly for assisting me with this problem.
#17
Hi Ruby2shoes, I ordered a walking foot with a 1/4 seam guide on it. In other words, I wanted it to measure a 1/4 inch seam as I sewed with the walking foot. That was the foot the machine would not zigzag with. My big mistake. Thank you all for giving suggestions to help me. The minky quilt is now at the LAQs.
Thread
Thread Starter
Forum
Replies
Last Post