Koala Cub machine surface not level...help
07-19-2023, 01:59 PM
#1
Member
Thread Starter
Join Date: Jul 2023
Posts: 2
Koala Cub machine surface not level...help
Hi
I inherited a Koala cabinet from my mother. From this forum I figured out how to raise and lower the machine surface. I just push down to lower. To raise I just put my hand under the surface and lift up.
My question is - the surface that the machine sits on is not level it is like it was pressed too hard in one corner and now is not level. Is there a way to correct this problem.
thanks,
Christine
I inherited a Koala cabinet from my mother. From this forum I figured out how to raise and lower the machine surface. I just push down to lower. To raise I just put my hand under the surface and lift up.
My question is - the surface that the machine sits on is not level it is like it was pressed too hard in one corner and now is not level. Is there a way to correct this problem.
thanks,
Christine
07-19-2023, 02:27 PM
#2
Super Member
Join Date: Jun 2010
Location: The Deep South near Cajun Country, USA
Posts: 5,385
