That mythical wrong twist thread
11-29-2012, 01:36 PM
#1
Super Member
Thread Starter
Join Date: Jul 2009
Location: Southwest Kansas
Posts: 4,820
That mythical wrong twist thread
Found some. What a pain in the neck!!! It's a DMC metallic embroidery thread on a spool. It's three strands twisted together. You'd think since it's on a nice spool it would be for use on a machine. You'd think. It says on the back of the card "hand embroidery only." Mmmm, okay. How hard could it be to use on the machine???? Hard. It actually untwists as it goes thru the machine. All I can say is it's a good thing I only had to stitch around 7 appliques and they weren't big. Next time I want a metallic I'll buy something else. This stuff is going to my girlfriend that does hand embroidery!!
11-29-2012, 05:34 PM
#3
Power Poster
Join Date: Dec 2008
Location: Western Wisconsin
Posts: 12,930
I thought there were only two twists to spools. Regular American thread untwists correctly when the spool is in an upright position. European twists (crosswound spools) untwist correctly when the spool is in a horizontal position on the machine. Maybe this is the problem you encountered?
The other thing to consider is that machines require stronger thread. Many metallics cannot stand up to the wear-and-tear of going through the needle eye multiple times on the machine. That may be why the spool was labeled for hand embroidery only -- not strong enough, therefore likely to fray when put through the rigors of a machine.
The other thing to consider is that machines require stronger thread. Many metallics cannot stand up to the wear-and-tear of going through the needle eye multiple times on the machine. That may be why the spool was labeled for hand embroidery only -- not strong enough, therefore likely to fray when put through the rigors of a machine.
11-29-2012, 09:02 PM
#4
Super Member
Thread Starter
Join Date: Jul 2009
Location: Southwest Kansas
Posts: 4,820
I thought there were only two twists to spools. Regular American thread untwists correctly when the spool is in an upright position. European twists (crosswound spools) untwist correctly when the spool is in a horizontal position on the machine. Maybe this is the problem you encountered?
The other thing to consider is that machines require stronger thread. Many metallics cannot stand up to the wear-and-tear of going through the needle eye multiple times on the machine. That may be why the spool was labeled for hand embroidery only -- not strong enough, therefore likely to fray when put through the rigors of a machine.
The other thing to consider is that machines require stronger thread. Many metallics cannot stand up to the wear-and-tear of going through the needle eye multiple times on the machine. That may be why the spool was labeled for hand embroidery only -- not strong enough, therefore likely to fray when put through the rigors of a machine.
edited to add: thread twist info
https://www.superiorthreads.com/educ...st-definitions
Last edited by Scissor Queen; 11-29-2012 at 09:22 PM.
Thread
Thread Starter
Forum
Replies
Last Post
