Patterns?
#21
Bearisgray--absolutely right!! When it really matters, refer to the pattern and directions, but trust your instinct and don't blindly rely on the pattern. I always make a test block from cheap broadcloth. If the seams don't match, I start investigating.
#22
I use 50wt 2 ply thread or thinner for piecing. One thing is to be very sure there is no veering at the end of each seam. That will cock the edge of the block just enough to be wonky. One thing I did as a beginner was to machine baste the block, press and measure. If it was the correct size then I resewed it. If not exactly the right size, I found where I made the mistake. It takes practice but soon you will have the AhHa moment and you will be piecing like a pro.
#23
Member
Join Date: Feb 2012
Posts: 30
I use 50wt 2 ply thread or thinner for piecing. One thing is to be very sure there is no veering at the end of each seam. That will cock the edge of the block just enough to be wonky. One thing I did as a beginner was to machine baste the block, press and measure. If it was the correct size then I resewed it. If not exactly the right size, I found where I made the mistake. It takes practice but soon you will have the AhHa moment and you will be piecing like a pro.
#25
Power Poster
Join Date: Mar 2009
Posts: 15,639
If you are consistently off then I'd suggest that you find the true 1/4" on your machine. Can you change the needle position? I sometimes use that method. Or I use the 1/4" foot. Once you've done a few, you should get a feel for which ones will give you trouble and which ones should go smoothly. Just hang in there.
#26
i figure any quilt that requires a scant 1/4 is to be made by someone much more careful than i.
and yes. if i can figure out how to change my signature, it will say this:
"i am a master. if there is a way to screw it up, make it harder or turn it upside down i WILL find it."
good thing i love it so damn much!
aileen
and yes. if i can figure out how to change my signature, it will say this:
"i am a master. if there is a way to screw it up, make it harder or turn it upside down i WILL find it."
good thing i love it so damn much!
aileen
#27
Power Poster
Join Date: Dec 2010
Location: Michigan
Posts: 11,276
Fighting with blocks to get them to fit takes all the fun out of it for me. I'd rather spend 5 minutes at the beginning of a project to figure out where the heck my seam should be and avoid the hassle later on.
regarding the 'veering' issue. If you use a leader scrap of fabric and/or chain piece, I find it's easier to keep my stiches from veering off at the start. Unfortunately, when I chain piece I find I veer a bit at the end of the seam. I think I'm paying more attention grabbing the next pair of patches to sew then completing the ones I'm working on! I try and be a bit more patient, and i've also found that using a stiletto to guide the last stitches thru helps me.
Last edited by PaperPrincess; 05-20-2012 at 04:11 AM.
#28
I had that problem for a while, turned out when I cut I didn't include the mark on the ruler. That is as clear as mud. When I lined up on the 2" line I would cut before the line instead of after. The width of that line can make a huge difference.
Thread
Thread Starter
Forum
Replies
Last Post
craftybear
Links and Resources
12
08-30-2011 07:20 PM
craftybear
Links and Resources
3
07-18-2011 03:08 AM