Quiltingboard Forums

Quiltingboard Forums (https://www.quiltingboard.com/)
-   Main (https://www.quiltingboard.com/main-f1/)
-   -   Help!!!! (https://www.quiltingboard.com/main-f1/help-t113168.html)

SandyQuilter 04-04-2011 09:15 AM

Remember, no all patterns are created accurate--including those in books or on web sites. If something doesn't fit, it probably is in the error of the creator. Redraft on graph paper.

Sandy

mshawii 04-04-2011 09:38 AM

It would seem to me that the three squares should all measure the same. rather than the center one being 2 1/2".

Birdena 04-04-2011 09:41 AM

Thank you very much.

Originally Posted by catmcclure

Originally Posted by Birdena
I was at a class today and the measurements are just not adding up and I am terrible at math. I have been over and over the pattern and the measurments and when sewing the two rows together I am off about an inch. Here is a link to the pattern http://www.modabakeshop.com/2010/11/...ap-quilt.html. Would appreciate any help....Thank you

According to the instructions you were supposed to use the three center blocks as a guide/match point to put all the strips together.

I copied the photo on Moda's website and revised to show what your strips should have looked like after you put them together, before trimming the ends. The extra half-inch really is needed sometimes by some people. I know that the feeddogs on my machine occasionally "shrink" a strip by a very small amount. If you don't have that little bit extra, your end blocks would end up being trimmed off.


ncredbird 04-04-2011 09:50 AM

In the comments section below the quilt instructions there is a post saying that the pattern had been corrected as of yesterday 4/3/2011. I didn't do the math but apparently you are not the only one that was having issues with it.
Ann in TN

catmcclure 04-04-2011 10:18 AM


Originally Posted by mshawii
It would seem to me that the three squares should all measure the same. rather than the center one being 2 1/2".

The finished blocks are supposed to be 6-1/2 x 7-1/2. three 3" pieces would make an 8 inch strip which would have to be trimmed on both ends.

BettyGee 04-04-2011 01:29 PM

This may sound off the wall, but I would make the blocks and then adjust the strips accordingly to get the width measurements correct and work on down. Sounds like you've gotten the right answers from other folks.

Birdena 04-04-2011 02:28 PM

Thank you to everyone who has commented and offered help. I am on my way to getting it done...going to forget the math. Do the squares and add strips then trim off

PieceandLuv 04-04-2011 03:31 PM

have to say thanks to you for this pattern...even though it has a few problems it seems to be an easy quick pattern sew thanks again for the questions you asked and I will try this quilt also..........

Marvel 04-07-2011 11:41 AM

This seams to help me. When this happens I turn over the block and carefully check each seam. Some times I have got the seam wider in places. Also check the block after you cut the pieces. The first steps are where you learn the most. Best of luck to you.

rslindiana 04-09-2011 12:46 PM

The link has a period at the end that does not belong there. Click the link then back off the period at the end and the page will come up.


Originally Posted by ckcowl
clicked on link- got a 'page not found' message- how about describing the block- and the measurements you are using- are you an inch too big or an inch too small?



All times are GMT -8. The time now is 03:49 AM.