Ruler Foot Problem
I have been wanting to try ruler quilting for a while. Finally bought a ruler foot and my MIL loaned me a couple of her rulers. Am finally working on a quilt that I decided I would try the ruler on. I sew on a Janome 8900 memory craft. I can free motion quilt just fine. When I am using the "convertible free motion quilting foot" I can sew in all directions including backward. Zero issues. Now when I use the ruler foot and quilt backwards, I get big skipped stitches right before the thread breaks. Why would this be? If I slow down I can sew for slightly longer before the thread breaks, but I don't understand how a different foot would change things so dramatically.
|
Is the ruler foot adjustable? Is it possible that it is either too tight against the fabric or too loose. Either can cause skipped stitches.
|
If your foot height is adjustable, lower it until it almost rests on the sandwich.
|
Are you using a ruler foot with the convertible holder that you use for fmq or are you using a stand alone ruler foot?
Another question…do you have to set your machine to a ruler work setting? On my Janome 9400 I have to tell it that I’m doing ruler work. |
Make sure you are not pushing the ruler up against the foot too hard as that might deflect the needle causing skipped stitches.
|
If this is a fixed ruler foot and not the ruler "toe" that goes on the convertible foot, it's likely that the foot is too high off the fabric sandwich and it's allowing the thread to deflect the needle too much when you move the fabric.
If it's the toe on the convertible foot, you can adjust the height of the convertible foot so there is less needle deflection. Big skipped stitches, if there is no hole from the needle, can mean you are moving the fabric too fast. |
Originally Posted by SuzSLO
(Post 8560071)
Is the ruler foot adjustable? Is it possible that it is either too tight against the fabric or too loose. Either can cause skipped stitches.
|
Originally Posted by JanieW
(Post 8560075)
Are you using a ruler foot with the convertible holder that you use for fmq or are you using a stand alone ruler foot?
Another question…do you have to set your machine to a ruler work setting? On my Janome 9400 I have to tell it that I’m doing ruler work. The foot I am using is the stand alone janome 1/4 inch ruler foot, for high shank rotary hook models. |
Originally Posted by mkc
(Post 8560084)
If this is a fixed ruler foot and not the ruler "toe" that goes on the convertible foot, it's likely that the foot is too high off the fabric sandwich and it's allowing the thread to deflect the needle too much when you move the fabric.
If it's the toe on the convertible foot, you can adjust the height of the convertible foot so there is less needle deflection. Big skipped stitches, if there is no hole from the needle, can mean you are moving the fabric too fast. |
It's too high. It should just skim the fabric.
Watson |
All times are GMT -8. The time now is 01:29 PM. |