I use my straight needle plate when I am quilting, love it, helps a ton! I have used it for piecing, too. My husband put a small triangle of a bright royal blue electrical tape (I think it is) on the upper right corner of it for me. I always know that I have it on my machine, so therefore I don't change my stitch or move my needle and learn the hard way.
You could mark it with anything really.

I use mine.

They are nice. A new/sharper needle helps also.

OK I am going to open my self up. Show how ignorant I am and ask what is a straight stitch plate? I have made various quilts, table runners, baby blankets, and more. I have only one plate on my machine. How is the straight stitch plate different than the standard plate that came on my machine? I have a Simplicity that I purchased in "97" it isn't a fancy machine but has been a work horse for me. I have tried to find a site that could tell me but to no avail.

I would appreciate any help and it's ok if you laugh at me. BrendaK

l, too, use my straight stitch foot more often than not.

yes, it certainly helps...I like it!

Don't think you're ignorant at all - there's probably a few people who've read this and don't know either, but weren't brave enough to ask!

A straight stitch plate has a small round hole, just a bit bigger than the needle, whereas the generic or ordinary plates that normally come with modern machines, have a longish oval/kidney-shaped hole.

The long oval hole allows you to use the 'fancy' stitches such as zig-zag and blanket, which weren't usual on the older, traditional 'straight-stitch' models. Most modern machines now come with this bigger hole so the machines can use a variety of stitches - the needle 'swings' back and forth to make the stitch.

One of the disadvantages that this bigger hole has, is that it leaves plenty of room for fabric to 'disappear' into (something I am well acquainted with, particularly at corners). You may hear people commenting that their machine 'eats' their fabric and use small pieces of fabric at the beginning and end of sewing to prevent this (leaders and enders).

Some machines have a bigger appetite than others, lol. By using a straight-stitch plate, with a small hole, it prevents the fabric going into the hole and the need for leaders.

Yes, I have one and use it for all my piecing. Does the job as intended and makes life much easier!

Yes and I love it. My husband services sewing machines and he ordered one for my machine and it is nice to have for piecing.

My janome 9900 does not allow this to happen. It senses which needle plate is installed. Good thing!

sandy

I learned the same lesson. More than once!