I also use the rubber door stops. They are not expensive and they work great.

What do you do if the machine is in a cabinet with 4 legs, not solid back? The door stops would slip out from under the back legs.

I used to use door stops, don't know why I stopped. Must try it again. Thanks for the reminder.

I just read about this on a very old post on another web site about 2 weeks ago. I too bought door stops at $$ store. They are smaller than the ones that come from a hardware store and work great. I am so short it was a struggle to see well and this tilt allows me to look down on the machine instead of across from front to back. My quarter inch seams are much more accurate now. Never would have thought of that on my own.

I use rubber door steps. Works like a charm.

How neat is that! I just bought a new chair because I needed one that would raise me higher. Alas, it's not quite high enough, so I've been putting a pillow under me. I can hardly wait to try it, since I have so much trouble with my back and shoulders! Thanks for posting this tip! I actually use a small board under my laptop, but hadn't thought about it for my machine.

I've used some furniture coasters to tilt one of mine just a little bit, but it does make a difference. Never thought of using trim. Maybe I should try that. Thanks. :)

Pollytink you put the stops under the machine not the cabinet or table it is sitting on,

I'm so glad you brought this up!! I did this with my old machine and then when I got the new one, I just forgot to put the door stops under. Now I get why my neck and upper back have been so sore.... duh!!

Okay, I need some additional wisdom on this topic. I use a clear extension table that fits around my machine. If I tilt the machine it will no longer be even with the table. Do you think it would work for me to put the ext table and machine on a piece of plywood and tilt the whole thing?