Quilt Sew Clever II Software Problem
#1
Member
Thread Starter
Join Date: Aug 2018
Posts: 1
Quilt Sew Clever II Software Problem
I have the Quilt Sew Clever II software on my longarm. I purchased this machine and SW secondhand and received no lessons as the dealer went out of business. Can anyone explain to me how you evenly distribute your design rows? Once you give the SW your upper left hand corner and the lower right hand corner which becomes your pattern box (unless you change it), usually the software has room to do two rows of the design before you have to roll the quilt and start again. However, the software makes the first two rows very close together when it starts the second row but does not overlap them which is good. But depending on the design you choose, sometimes it does not start in one corner or the other but rather maybe in the middle when it starts up again. So how would you mark the spacing to start the third row and be sure that it does not overlap the one above it???? I am speaking of edge to edge quilting of course where you fill in the row automatically with the software. It seems no matter what I do or where I measure, the software either overlaps to the row above or leaves a half inch space between the rows. Where am I going wrong or what am I not understanding? Any thoughts would be appreciated. Thank you.
#3
Super Member
Join Date: Aug 2011
Location: Asheville, previously Lake Vermilion, Tarpon Springs, Duluth, St Paul, Soudan
Posts: 1,651
No personal knowledge of this system. Do you have the manual? If not, you can get it here:
http://new.husqvarnaviking.com/SiteM...-II-Manual.pdf
http://new.husqvarnaviking.com/SiteM...-II-Manual.pdf
Thread
Thread Starter
Forum
Replies
Last Post