2 of my spiral tablerunners
11-19-2010, 01:02 PM
#51
Super Member
Thread Starter
Join Date: Jun 2009
Location: BC Canada
Posts: 1,035
Originally Posted by Alfie
I see guess I didn't look a that part close enough DUH. Pattern is a little confusing but once I figured it out it really isn't that bad. Just have to be very careful cutting it out.
11-19-2010, 01:54 PM
#52
Super Member
Join Date: Oct 2009
Location: Maine
Posts: 1,376
I took the measurements to my local hardware store and had them cut a piece of plexiglass to the size. Then I took the stick on ruler tape that comes in a roll and and put a piece of that down the middle starting at the beginning of a one inch mark so that it would be accurate. I did this because I didn't find the ruler at a price I wanted to spend. It cost me less than $4 to make.
11-19-2010, 04:47 PM
#55
Super Member
Join Date: Oct 2009
Location: Maine
Posts: 1,376
I went back and researched it again. I got the measurements here from someone called Magpie who posted it in answer to someone else's question I guess. I got it through googling. Anyway, it is:
22.5 inches long. 1 inch wide at one end and 4.78 wide at the other end. This includes the 1/4 inch seam allowance.
22.5 inches long. 1 inch wide at one end and 4.78 wide at the other end. This includes the 1/4 inch seam allowance.
Originally Posted by debbiewi
Omaof Four - where did you get the measurements?
debbie
debbie
11-19-2010, 05:14 PM
#56
Super Member
Join Date: Oct 2009
Location: Maine
Posts: 1,376
I am going to try to attach a pic of the markings so that you can see what is on the original ruler in addition to the strip of tape like I put on mine.
Not sure if either of these will appear but am giving it a try. If not, PM me with you email address and I will see what I can do that way.
Not sure if either of these will appear but am giving it a try. If not, PM me with you email address and I will see what I can do that way.
10 degree wedge ruler
[ATTACH=CONFIG]129732[/ATTACH]
Thread
Thread Starter
Forum
Replies
Last Post
