A Friend Asked Me If I Knew the Name of this Quilt Pattern
#71
4. On the corner of your ruler find the point that is 1/4" in from the bottom and 1/4" from the left side. Place that spot over any point in the seam between the middle strip and the bottom strip.
Once you've got that lined up, place the similar marking in upper right corner of your ruler on a spot in the seam between the middle strip and the top strip.
Make sure that the lower left corner is still lined up correctly.
Another spot to check are the other seams on the left and right sides. They should line up with the 3 1/4" mark on the ruler. On the ruler in the photo the line is in white. You can fudge this a bit, but not too much!
Once you've got that lined up, place the similar marking in upper right corner of your ruler on a spot in the seam between the middle strip and the top strip.
Make sure that the lower left corner is still lined up correctly.
Another spot to check are the other seams on the left and right sides. They should line up with the 3 1/4" mark on the ruler. On the ruler in the photo the line is in white. You can fudge this a bit, but not too much!
Last edited by LyndaOH; 04-15-2012 at 10:07 PM.
#73
#76
Put a plaid/print stripe between two strips of solid then cut the squares on a bit of a angle. Easy. Good use of scraps.
#79
My pleasure! It can be made any size. The key measurement is the width of the center strip. Take your finished block size, divide in half and add 1/4". (You'd normally add 1/2" but since this is sewn at an angle you don't want the full 1/2".) So if you want an 8" finished block, the center strip would be 4 1/4" wide.
I do think you'll waste a lot of fabric with this method so when I make one (it's now on my very long list!) I'm going to make the top and bottom triangles from a rectangle. This will be much easier if I figure out how to trim the corners of the triangles so they line up properly with the central strip. I'll be working on that and will post a "trimmer" when I get it figured out.
I've also been experimenting with colors/values and you can create some really neat effects by varying the values of the darks. Here's an example:
I do think you'll waste a lot of fabric with this method so when I make one (it's now on my very long list!) I'm going to make the top and bottom triangles from a rectangle. This will be much easier if I figure out how to trim the corners of the triangles so they line up properly with the central strip. I'll be working on that and will post a "trimmer" when I get it figured out.
I've also been experimenting with colors/values and you can create some really neat effects by varying the values of the darks. Here's an example:
Thread
Thread Starter
Forum
Replies
Last Post
miss_ticky2
Pictures
71
01-09-2013 05:59 AM
calicocat
Pictures
9
04-26-2012 10:30 AM