I Did It! I made an extension table for my workhorse machine!
#1
Senior Member
Thread Starter
Join Date: Oct 2007
Location: NW Ohio
Posts: 616
it was easier than i anticipated it to be! purchase the board, have them cut it, cut out the 'notch' with an electric handsaw, cut the legs from a 1.5" dowel rod, add the leveling feet, stain, and varnish!
yay me!
[img]http://i42.photobucket.com/albums/e3...1/IMG_1112.jpg[/img]
[img]http://i42.photobucket.com/albums/e3...1/IMG_1114.jpg[/img]
p.s. i paid big money for one for my Janome, but because of the clean lines on this one, i did it myself for about $15 (not including the cost of power tools that i should have had anyway and will use for other projects).
yay me!
[img]http://i42.photobucket.com/albums/e3...1/IMG_1112.jpg[/img]
[img]http://i42.photobucket.com/albums/e3...1/IMG_1114.jpg[/img]
p.s. i paid big money for one for my Janome, but because of the clean lines on this one, i did it myself for about $15 (not including the cost of power tools that i should have had anyway and will use for other projects).
Thread
Thread Starter
Forum
Replies
Last Post