New Sewing Table Pics! Finally...
#15
Member
Thread Starter
Join Date: May 2012
Location: Central O-H-I-O!
Posts: 36
Getting the right size for my acrylic table was easy, I just measured it and cut it out. I cut it a little shy of my measuring just to be on the safe side and then I sanded it down to where I needed it. It is just two squares cut out and connected. I did build it too low for my machine, but I just sat my machine on a 1/2" board, drew around it and then cut it out and put it underneath my machine. I then mitered around the edges so my acrylic table would sit down in perfect. Really, it was pretty easy and a heck of alot cheaper than if I wanted to buy one like that. And I already had all the wood left over from the barn so I didn't have to buy anything at all.
#17
Member
Thread Starter
Join Date: May 2012
Location: Central O-H-I-O!
Posts: 36
Tartan - the bathroom is right beside me, you can see the wall boxed in there. I might take some more pics and post them tomorrow when I post pics of my first quilt. And the kitchen is right behind me. It's not a full kitchen, I just built a horseshoe bar, put a counter top stove in the bar, and I have a little fridge under the bar counter. I say little fridge but that little sucker will hold 5 cases of beer! Lol...
Thread
Thread Starter
Forum
Replies
Last Post