I have finished cleaning and getting my World Rotary machine I found on CLs. It need the wiring replaced which I think I can do. I am assuming the motor and controller both work. My question is what type of wire do you buy?
Also, is there some cleaning to do to the motor. The brushes had just a pit of carbon on them. But do you open up the motor and clean all the grung from it?
Would you replace the light or just leave it off? It was mounted on the front of the machine so I think it is one that I may burn my hand on. But I may be able to mount it on the back but not sure on the bracket.
Sorry this is so long winded.
Motor showing wires to light - 2 wire
[ATTACH=CONFIG]103273[/ATTACH]
Power cord off machine to controller - 3 wire
[ATTACH=CONFIG]103274[/ATTACH]
controller in cabinet for knee lever
[ATTACH=CONFIG]103275[/ATTACH]