My design wall is very portable. My hubby bought 2 - 10' PVC pipe. I think it was 2". He also bought 4 Elbows. Then he cut the pipes in half. I had him leave the elbows off until I made the fabric fit. I used one of those soft rolled up blankets I found marked down at Dollar General but you could use flannel or whatever you want. I measured and sewed a Sleeve on each side. I had to leave about 4 inches from each end so it would fit snug and then put the PVC pipes through each one then put elbow on and connected. You will see what I mean about the fit once you have all elbows connected. I will try to get a picture oF mine to post.