These instructions are for a square potholder. If using tile the size should be 1 Inch larger than tile
Make front of pot holder as you want . Layer in this order: 1 LW batting ,1 insul bright, quilt as desired,pin the hanger (if desired) making sure pin is not is SA,
Cut 2 pieces for back of potholder. Hem one end (this will be the one that tile will go in. Serge (cutting off 1/2")the second back on one end.
Layer FRONT of PH face up with top of PH at top. Next place hemmed back face down, with raw edges even at top. Next place serged back face down with raw edge even at bottom. (Note the 2 backs are shorter than front and are layer so the short ends are opposite each other) Pin making sure pins are not in seam allowance. Serge or sew all around potholder without leaving an opening. Remove pins and turn twice.