Originally Posted by
aronel
That's a name you don't hear very often. If you read my name backwards - you will see why I like it.
I totally understand your anxiety. I snapped a foot from a high shank Necchi on my Singer 401 and got it out of timing in 2 seconds.... The Necchi foot was a bit taller than the slant feet.
I don't know why it wouldn't fit if it is a low shank walking foot. But as a precaution, take a good look at the walking foot. Does that shank look to be the same height when held up to an attachment that really does go on your machine? Then if it seems so (it should) try it on the machine. Don't let it snap down hard and fast - do it slow & don't run it yet. Then look and see if there is anything it needs to clear - thread cutter? anything it would hit. Then test it by hand turning it. Does it work for a couple inches? If so try running the machine.