Originally Posted by
lots2do
I'm having a hard time visualizing that.
I can understand the confusion--basically it uses the base of the rolling chair, along with a part of the post that holds up the chair seat--then you put a piece of PVC plastic pipe over the post part and just drop the roll of bat (the cardboard part) over the PVC pipe--that way you can pull out the amount of bat needed and cut straight down. For those that have worked in a school, it's like the big rolling carts for the butcher paper that is used on bulletin boards, etc. And by having it standing upright, the roll doesn't take up as much room. But I can't figure out how to get the lift part off the chair assembly--my husband rescused a chair base from the trash for me and I'd like to get this taken care.