View Single Post
Old 02-25-2019, 03:53 AM
  #8  
maudeflanagan
Senior Member
 
maudeflanagan's Avatar
 
Join Date: Jan 2016
Location: Michigan
Posts: 354
Default

So I have been sewing on my machine periodically (I bought it mainly for sewing while at someone else's house) and I have noticed there is something it's struggling with. I was sewing some HSTs in a 9-patch formation, and anytime I had to start a seam where there was a diagonal HST seam at the beginning, the machine struggles to pull the fabric under the needle. I tried using a leader scrap bit of fabric to make sure the fabric wasn't sucked into the needle plate, but this didn't help.

I believe the 1030 only came with a zigzag plate, so I don't know if I can get a straight stitch plate for it or if that would help. It almost feels like the feed dogs are unable to grab the fabric like they are supposed to. The feed dogs are moving as they should as far as I can see. I tried adjusting the presser foot pressure, that doesn't seem to help.

Anyone have any ideas for the problem or a solution?
maudeflanagan is offline