Thread
:
need input on a new sewing table
View Single Post
04-30-2019, 06:34 PM
#
3
Stitchnripper
Power Poster
Join Date: Nov 2009
Location: Mableton, GA
Posts: 11,203
I have an Arrow table that I can fit my machines into. I butt them up to the front and left side edge of the table wedge them in with anything that will fit flush. The tray the machines sit on is adjustable. I have no problem with this set up
Reply
Stitchnripper
View Public Profile
Send a private message to Stitchnripper
Find More Posts by Stitchnripper