Thread: Enlarging a block with multiple components.
View Single Post
Old 06-03-2022, 06:54 AM
  #9  
bearisgray
Power Poster
 
Join Date: May 2008
Location: MN
Posts: 24,441
Default
Originally Posted by Gay View Post
To keep these patches in proportion you would end up with a 24" block. If you don't mind this you would have a 16 patch block with each block finishing at 6". The HSTs would finish at 3".
Hope I have helped.
Thank you for drawing that out. Your drawing helped me see the cutting/piecing lines that I was unable to determine from the picture on the link.
bearisgray is offline  
Reply