Gap inside my binding
#21
Originally Posted by hutch farm
Is it really sloppy craftmanship to have a gap between the edge of your quilt and the top of the binding strip? It called for a 4 inch binding strip. I sewed it onto the front of my quilt but when I flip it over to sew the back down by hand, there is a space or gap between the binding. Most of the time my binding strips are tight against the seam but in this case there is a gap between the top of the strip and the seam. Did I mess up or what? Thanks for your help. Also, will the binding pucker if there is nothing in the top part of it? Make sense?
#23
I'm wondering if you mean that the strips for the binding start out at 4"...then folded in half you have a 2" binding to sew onto the front, doubled for more strength, and then the edge rolled to the back for hand stitching. That's how I do it.
#25
Super Member
Join Date: Jul 2010
Location: Central Willamette Valley, Oregon, USA
Posts: 7,695
Originally Posted by Holice
should the 4" have been folded for a double binding.
guess i'm a little dumb tonight, but i don't understand what you mean by gap. did the binding not fit. was it too short or too long for the quilt. if too short then should add some to it, it too long the cut some off. i'm real hazy about what you are describing.
guess i'm a little dumb tonight, but i don't understand what you mean by gap. did the binding not fit. was it too short or too long for the quilt. if too short then should add some to it, it too long the cut some off. i'm real hazy about what you are describing.
Thread
Thread Starter
Forum
Replies
Last Post
quilter1
General Chit-Chat (non-quilting talk)
6
06-22-2010 07:16 PM