Singer 319 in need of TLC
11-07-2011, 10:23 AM
#91
Power Poster
Thread Starter
Join Date: Mar 2011
Location: Somewhere
Posts: 15,507
Originally Posted by bannie
I got one just like that today . How did you get the top off? bannie
http://parts.singerco.com/IPsvcManuals/306W25.pdf a link to a user's manual
and a repair manual - this covers all "swing needles" http://parts.singerco.com/IPsvcManuals/306W25.pdf
Last edited by miriam; 11-07-2011 at 10:42 AM.
11-07-2011, 10:28 AM
#92
Power Poster
Thread Starter
Join Date: Mar 2011
Location: Somewhere
Posts: 15,507
Originally Posted by miriam
It is to keep the gears lubricated. The pot just had a couple screws holding it on. I pulled them off and cleaned the grease out with a screw driver end - then I painted it with the kerosene and turned it a bit to wash it out good inside where I can't see. Lots of goo came out of there. I painted until it ran clean again. I'll pack it full of grease when I get that far. You all have to stay tuned in a week or two for part 2 of the continuing saga of 'Mr Ed the 319w before his time sewing machine'. I am fascinated by the engineering on the older zig zag machines. Each one is unique isn't it? I'm pretty sure I need to do something to the stitch length regulator - it doesn't travel.
11-11-2011, 02:17 PM
#97
Power Poster
Thread Starter
Join Date: Mar 2011
Location: Somewhere
Posts: 15,507
Bloomin' Iris came over today and we got Mr. Ed's tension apart and put back together. It took 5 tries to get the spring in the right place but we got it. Then we figured out the zig zag adjuster. I'm waiting on some needles from Sew-Classic - then I have to put the needle bar back together. It is made with some kind of little plug in the hole and I haven't quite figured that out yet. Anybody know much? Mr. Ed's cabinet front is really a door. Behind the door is a big hole on the left. To change the bobbin you reach in through the hole in the front and change it. I don't think it can be changed from the slide plate with out being an acrobat with a very small hand. I shot a pic of the tension off and then after we replaced it - let's see if it loads.
11-11-2011, 02:22 PM
#99
Power Poster
Thread Starter
Join Date: Mar 2011
Location: Somewhere
Posts: 15,507
pictures are kind of blurry but we did get it on and the tension seems to do what it should do. Mr Ed still needs some fine clean up. So it will be q tip work for a while - lots of dirty little corners and such. There is still more gunk on the stitch selector slide - seems like even a few specks keep things from moving well.
11-11-2011, 02:26 PM
#100
Power Poster
Thread Starter
Join Date: Mar 2011
Location: Somewhere
Posts: 15,507
Originally Posted by Candace
Miriam, you can change the bobbin by removing the plate. But, the paint will get chipped over time, doing it that way.
Thread
Thread Starter
Forum
Replies
Last Post
KenmoreRulesAll
For Vintage & Antique Machine Enthusiasts
30
09-04-2019 05:53 AM
