Twister Quilt
#11
Super Member
Join Date: May 2007
Location: NE Pa.
Posts: 1,738
The thing I like best about the twister ruler is the little "nubby's" on the back of the ruler which keeps it from sliding when you are cutting it out. I made a quilt using the large ruler and the blocks were six across and 7 down with two borders. It just covers my queen size bed with no hang over on the sides. But that OK , its not for me anyway. LOL
#13
Super Member
Join Date: Jul 2010
Location: Glenmoore, PA
Posts: 7,941
Somewhere on the web I found a pattern / how to make your own twister ruler. Ie where to put the intersections it worked very well cut from clear plastic.i did think after I bet you could somehow line up on a square ruler. It would be useful while waiting for twister ruler. There are different sizes not sure if lines if different places.
Let's twist again fun day.
Let's twist again fun day.
#15
Member
Thread Starter
Join Date: Mar 2012
Posts: 5
[QUOTE=LavenderBlue;5684791]TWISTER
On the 3.5 inch TWRuler the mark is at 3/4 inch. Use 5" blocks & 3.5" borders.
On the 8 inch TWRuler the mark is 2 inches. You start with a 10" square and 6.5" borders.
A 6 row by 6 row will finish at about 61 x 61...you can then add more borders if you want.<o
Thank you -- just the info I needed! The new ruler has come and I already have the "Li'l Twister" -- This is going to be so much fun!
</o
On the 3.5 inch TWRuler the mark is at 3/4 inch. Use 5" blocks & 3.5" borders.
On the 8 inch TWRuler the mark is 2 inches. You start with a 10" square and 6.5" borders.
A 6 row by 6 row will finish at about 61 x 61...you can then add more borders if you want.<o
Thank you -- just the info I needed! The new ruler has come and I already have the "Li'l Twister" -- This is going to be so much fun!
</o
Thread
Thread Starter
Forum
Replies
Last Post
craftybear
Links and Resources
7
06-17-2015 07:18 AM
craftybear
Links and Resources
5
11-26-2011 06:41 PM
craftybear
Links and Resources
12
09-16-2011 02:12 PM
craftybear
Links and Resources
5
05-26-2011 04:07 PM