Wonder Cut Ruler
#2
Power Poster
Join Date: Dec 2010
Location: Michigan
Posts: 11,276
Looks like the ruler is set up for specifically sized finished HSTs that fall on the inch or half inch measurement. What size triangle are you trying to make? Cutting 4 5/8" strips could yield different size HSTs depending on what they want you to do with the strips once they've been cut.
#3
Junior Member
Thread Starter
Join Date: Mar 2010
Location: Massachusetts
Posts: 102
Looks like the ruler is set up for specifically sized finished HSTs that fall on the inch or half inch measurement. What size triangle are you trying to make? Cutting 4 5/8" strips could yield different size HSTs depending on what they want you to do with the strips once they've been cut.
#5
#7
It pays to keep up with the new, but also to remember the past! I would go back to the old way for this one, but only make the first one or two and while doing that, you might think of a way to convert it to the ruler. If not, you've at least made a start on it. Shiree.
Thread
Thread Starter
Forum
Replies
Last Post
craftybear
Links and Resources
3
08-08-2011 01:07 PM