Quilter cut off seam allowance. Please HELP!
07-27-2014, 03:07 PM
#11
Super Member
Join Date: Aug 2013
Location: Florida
Posts: 5,896
Look at it this way, if she cut it off, she may not notice if the binding is cutting the pattern short. But just to be safe, give her a call and explain the situation. There is very little you can do at this point.
07-27-2014, 03:08 PM
#12
Senior Member
Join Date: Jul 2012
Location: Long Island
Posts: 798
What you can do is faux knife edge binding. It is a proffered method for wall hangings and art pieces if you do not want to do the tricky but wonderful knife edge binding. This is what you do. You make a narrow, folded binding, just like the regular binding but narrower, and you sew it to the front of your quilt as close to the edge as possible. You work on one side of the quilt at the time, staring in one corner and finishing in the other. When you are done sewing one side, you flip the binding to the back so none of it is visible in the front and you hand stitch it to the back. People say that It is not as strong as regular binding because the edge of the quilt which is exposed to wear and tear is part of your quilt top and not the binding. But seriously, how often have any of us seen a worn out binding in our lifetime? Good luck!
07-27-2014, 03:31 PM
#14
Member
Thread Starter
Join Date: Jul 2014
Location: Greensboro, NC
Posts: 3
I'm attaching pic here (i hope). I've stitched around the edge where the seam allowance should be. As you can see, there's NOTHING in the corner. The flange solution suggested earlier could work really well.
07-27-2014, 03:57 PM
#16
Super Member
Join Date: Feb 2014
Location: Wis
Posts: 5,928
I don't think it would be noticeable on that quilt if you just did a normal binding. Really, I don't think it would look bad. Personally I'd be leery of using too narrow of a seam allowance to sew on the binding as there's more of a chance it would tear away from the quilt with washing and use.
07-27-2014, 04:17 PM
#19
Banned
Join Date: Jul 2014
Location: Arkansas
Posts: 57
Originally Posted by Tashana
What you can do is faux knife edge binding. It is a proffered method for wall hangings and art pieces if you do not want to do the tricky but wonderful knife edge binding. This is what you do. You make a narrow, folded binding, just like the regular binding but narrower, and you sew it to the front of your quilt as close to the edge as possible. You work on one side of the quilt at the time, staring in one corner and finishing in the other. When you are done sewing one side, you flip the binding to the back so none of it is visible in the front and you hand stitch it to the back. People say that It is not as strong as regular binding because the edge of the quilt which is exposed to wear and tear is part of your quilt top and not the binding. But seriously, how often have any of us seen a worn out binding in our lifetime? Good luck!
07-27-2014, 04:40 PM
#20
Super Member
Join Date: Oct 2013
Location: Tulsa, Ok
Posts: 4,582
I also think a normal binding will be fine on this quilt. The fact that part of the outer edge of the blocks will be about 1/4" narrower than the other two rectangles in the block will never be noticed by anyone except you. Nice quilt!
Thread
Thread Starter
Forum
Replies
Last Post
craftybear
Links and Resources
5
10-01-2011 07:09 PM
craftybear
Links and Resources
6
10-01-2011 07:03 PM
craftybear
Links and Resources
4
10-01-2011 07:02 PM
