Go Back  Quiltingboard Forums >
  • Main
  • Do I need to quilt lines in both directions to secure batting? >
  • Do I need to quilt lines in both directions to secure batting?

  • Do I need to quilt lines in both directions to secure batting?

    Thread Tools
     
    Old 12-29-2024, 10:27 AM
      #1  
    Junior Member
    Thread Starter
     
    Join Date: Dec 2024
    Posts: 116
    Default Do I need to quilt lines in both directions to secure batting?

    I'm working on my first quilt and I quilted diagonal wavy lines 3" apart.

    Do I have to quilt in the opposite direction (cross hatching) to secure the batting?

    I'm using Pellon natural cotton batting with scrim which I preshrunk. Packaging states the recommended stitching distance is 8-10".

    My neck, shoulders & arms are NOT enjoying the quilting process. At least not as much as I enjoyed the piecing process!
    dpendleton is offline  
    Old 12-29-2024, 10:38 AM
      #2  
    Junior Member
     
    Join Date: Oct 2020
    Location: Virginia
    Posts: 295
    Default

    I have done baby quilts this way and they were fine. Granted, I only washed them once before giving them to the recipients, but that first wash didn't displace any batting. I would think since you're using a batting with scrim, and since the directions recommend a sewing distance of 8 to 10 inches, you should be just fine with the 3 you're doing. If there's some way you can elevate your sewing chair, perhaps with a cushion, that might help your neck, arms, and shoulders. Sitting at a higher orientation above the sewing machine bed may help some.
    Synnove is offline  
    Old 12-29-2024, 11:06 AM
      #3  
    Power Poster
     
    Join Date: Nov 2009
    Location: Mableton, GA
    Posts: 11,681
    Default

    I use that batting all the time and never preshrink it with fine results. I think your wavy lines 3" apart are good. In my quilting opinion, it has never mattered going one direction and then the other. Agree with adjusting position to make it less uncomfortable. If the quilt goes through easily and you are not "hunching over" you should feel better.
    Stitchnripper is offline  
    Old 12-29-2024, 11:44 AM
      #4  
    Power Poster
     
    dunster's Avatar
     
    Join Date: Mar 2009
    Location: Lake Elsinore, CA
    Posts: 15,559
    Default

    When the batting says 8-10", what I believe it means is that from any point in the quilt you shouldn't be able to move more than 8-10" without hitting a seam line. Quilting diagonal parallel lines would not meet that requirement.

    However - I don't actually know whether your batting will shift, come apart, ball up, or otherwise misbehave. I personally wouldn't take the chance, especially if the quilt will be washed often.
    dunster is offline  
    Old 12-29-2024, 12:08 PM
      #5  
    Junior Member
     
    Join Date: Nov 2015
    Posts: 217
    Default

    I agree with Dunster. If it were me I would do "something" every 8-10" in those diagonal unquilted parallel fabric sections. Especially if it's a quilt that might get a lot of use and therefore be washed a lot.
    lmanna is offline  
    Old 12-30-2024, 04:38 AM
      #6  
    Super Member
     
    aashley333's Avatar
     
    Join Date: Oct 2019
    Location: Corpus Christi, Texas
    Posts: 2,813
    Default

    I think it will be just fine w/o more quilting. Most of my early quilts had minimum quilting, and they have held up well. I get nervous on the FMQ step because my sit down longarm is new, so I quilt in small sessions with lots of breaks.
    aashley333 is online now  
    Old 12-30-2024, 09:43 AM
      #7  
    Super Member
     
    Join Date: Jan 2014
    Location: Central NM
    Posts: 1,715
    Default

    I always quilt diagonal lines both ways on all my quilts because I like the way the quilting looks when it is finished. IMHO quilting one way only looks unfinished.
    Julienm1 is offline  
    Old 12-30-2024, 06:09 PM
      #8  
    Senior Member
     
    Join Date: Oct 2012
    Posts: 836
    Default

    On my last one, I did just as you did, with diagonal channel quilting in one direction, but then followed up with straight lines across the width. It looked rather cool on the back. But I was using a batt without a scrim and the quilt was larger.

    hugs,
    charlotte
    charlottequilts is offline  
    Old 12-31-2024, 12:46 AM
      #9  
    Member
     
    Join Date: Dec 2023
    Location: Central Georgia
    Posts: 89
    Default

    Originally Posted by dunster
    When the batting says 8-10", what I believe it means is that from any point in the quilt you shouldn't be able to move more than 8-10" without hitting a seam line. Quilting diagonal parallel lines would not meet that requirement.
    I'm not so sure the guidelines mean that. If so, then parallel lines 1/2 inch apart wouldn't meet the requirement either. Although, I wouldn't feel good with only parallel lines 8 inches apart, I would feel perfectly fine with wavy diagonals 3 inches apart.
    sloscotty is offline  
    Old 12-31-2024, 03:28 AM
      #10  
    Super Member
     
    Join Date: Aug 2011
    Posts: 3,863
    Default

    I would contact Customer Service for your batting brand and ask your question. I will be interested to find out the correct answer as well.
    copycat is offline  

    Posting Rules
    You may not post new threads
    You may not post replies
    You may not post attachments
    You may not edit your posts

    BB code is On
    Smilies are On
    [IMG] code is On
    HTML code is On
    Trackbacks are Off
    Pingbacks are Off
    Refbacks are Off



    FREE Quilting Newsletter