More ?s about binding
02-18-2011, 11:55 PM
#11
Senior Member
Join Date: Jun 2009
Location: "stashed" away in a mound of fabric
Posts: 655
I like to use bias binding for most of my quilts, and absolutely for ones with curved edges. Also, it depends on how much fabric I have--if I'm running short of fabric for the binding, I'll do whatever fits best--usually straight of grain for something like that. I believe that bias binding will wear better than straight of grain, too.
02-19-2011, 03:26 AM
#12
Power Poster
Join Date: Feb 2009
Location: Northern Michigan
Posts: 12,861
depends on the quilt and the binding fabric. some fabric may look better cut on the bias; you always need bias if going around curves, if you rounded your corners instead of straight corners and it is easier to (ease) your binding around the quilt if it is bias cut. if your quilt is just straight lines straight binding is ok to use...it's a personal choice
02-19-2011, 04:58 AM
#15
Senior Member
Join Date: May 2010
Location: Atlanta, Texas
Posts: 623
Originally Posted by ktbb
bias is obviously good for use on curves, but there is another advantage of using it for even straight edge...it lasts longer. Remember that "rips" from simple wear and tear normally occur along the thread lines - either on grain or cross grain = you don't get rips on the bias. When you fold a straight grain binding over the edge of a quilt, it leaves one or two threads running right on the edge of the binding the whole way around...and if and when those threads get worn, a rip starts and continues along the edge of the quilt. With a bias binding, there is no one thread that runs along the edge...all threads cross it at an angle. If one of those threads gets worn, that one thread may break from the wear, but you don't get rips/slits appearing because adjacent bias threads hold the fabric together.
When I started quilting, I researched this topic and found this information. It makes sense and explains why Granny said to always use bias binding and why her bindings from decades ago still look great.
02-19-2011, 07:20 AM
#17
Senior Member
Thread Starter
Join Date: Jan 2011
Location: In the middle of an Oklahoma wheat field
Posts: 840
Originally Posted by ktbb
bias is obviously good for use on curves, but there is another advantage of using it for even straight edge...it lasts longer. Remember that "rips" from simple wear and tear normally occur along the thread lines - either on grain or cross grain = you don't get rips on the bias. When you fold a straight grain binding over the edge of a quilt, it leaves one or two threads running right on the edge of the binding the whole way around...and if and when those threads get worn, a rip starts and continues along the edge of the quilt. With a bias binding, there is no one thread that runs along the edge...all threads cross it at an angle. If one of those threads gets worn, that one thread may break from the wear, but you don't get rips/slits appearing because adjacent bias threads hold the fabric together.
02-19-2011, 08:14 AM
#19
Super Member
Join Date: Mar 2010
Location: Anchorage, AK
Posts: 1,393
Originally Posted by Linda B
I've only used straight, but I do have a question about bias binding: Is it more difficult to sew on because of the tendancy of bias to stretch?
Thread
Thread Starter
Forum
Replies
Last Post
craftybear
Links and Resources
0
11-03-2011 01:23 PM
craftybear
Links and Resources
3
05-07-2011 10:05 AM
craftybear
Links and Resources
3
12-25-2010 09:49 PM
