Help with Free-motion quilting Breaking too many needles
#11
This wouldn't be a Sapphire would it? I have one, and had the same trouble.
Check that the thread isn't getting hung up somewhere along the thread path - it can even snag on the spool. If you have the spool on the horizontal spindle, try the vertical. A separate thread holder might help, too.
It's also possible that you nicked the needle plate after you broke a needle. You can use crocus cloth - a very, very fine sandpaper - to smooth out any burrs you might feel.
If this is a Sapphire, make sure it's set up for free motion quilting. There's an item in the tools section for "pivot height," and you can try to set this to -2 --that hint is actually buried in the users manual.
I hope this helps - good luck.
Janet
Check that the thread isn't getting hung up somewhere along the thread path - it can even snag on the spool. If you have the spool on the horizontal spindle, try the vertical. A separate thread holder might help, too.
It's also possible that you nicked the needle plate after you broke a needle. You can use crocus cloth - a very, very fine sandpaper - to smooth out any burrs you might feel.
If this is a Sapphire, make sure it's set up for free motion quilting. There's an item in the tools section for "pivot height," and you can try to set this to -2 --that hint is actually buried in the users manual.
I hope this helps - good luck.
Janet
#14
Originally Posted by sandpat
Loretta is absolutely right...you need to try all these things, then you need to "hold your mouth just right"..well, thats what my Mom used to always say..
#17
thanks for asking this question, I've been having the same problem but just on one particular quilt. I never thought of using a denim needle. It's a Christmas quilt (well not gonna be done this year!) and I used some cheap polyester batting because it's just a wall hanging, plus some thick muslin for the backing. I'm going to pick up some denim needles and give it another try.
#18
Senior Member
Thread Starter
Join Date: Oct 2009
Location: Utah
Posts: 435
Thanks to everyone for your suggestions. I got some very very fine sandpaper, and smoothed out the throat plate. I did try a size 16 jeans needle, and my thread kept fraying, so I went back to a 14 quilting needle, and I did not break a needle at all. When I told my dh about some of the suggestions, he liked the sandpaper idea, so that was one of the first things I tried this morning.
This board is wonderful with so many knowledgeable people on it.
Thanks again
This board is wonderful with so many knowledgeable people on it.
Thanks again
#20
My bobbin winder on my Viking Designer I sometimes winds threads too tightly. If I happen to be free motion quilting quickly, the bobbin thread pulls on the needle and causes it to break. If I unwind a few inches of thread from the bottom and cut it off, I'm sometimes lucky enough to reach a part of the bottom that has been wound better and then my fmq goes smoothly. If not, I change my bobbin and try again.
Thread
Thread Starter
Forum
Replies
Last Post
Jamasue
Main
21
07-25-2015 05:10 PM
TeeGee
For Vintage & Antique Machine Enthusiasts
23
05-21-2012 09:03 AM