OK, I need help
#1
OK, I need help
There is no better place to ask for help than on the QB. I have a DSM Brother 1500S. I have quilted 3 quilts on it and have had no problems whatever. I am trying to quilt my Prairie Peony and am having all kinds of problems. The only thing different, I am using 2 layers of cotton batting. I don't usually use cotton. I have cleaned, re-threaded, changed needles, using needles recommended for the thread, changed threads and I still get skipped stitches. I will be going along just fine and suddenly it may skip a length an inch long. I can sew like forever on a sample using the same fabric and batting, no problems. Then let me put the quilt back on and here we go again. I have battled this for a couple days so decided to see if anyone has the magic answer. Thanks for any replies.
#2
Power Poster
Join Date: Dec 2010
Location: Michigan
Posts: 11,276
Two things, first, what size needle are you using? and second, I'm thinking that the quilt is not being supported enough, especially since a small version works OK. Do you have an extension table? Is the whole quilt up on the table?
#3
Power Poster
Join Date: Jun 2011
Location: Southern California
Posts: 19,127
I quilt on a Bernina and have never used two layers of batting. Yes, check that you are using a new sharp needle maybe 14 to 16 size. You are going thru two layer for cotton batting probably with two layers of scrim. That is a bit of bulk in my opinion but I have read threads where it has been done. Not sure if it has only been done on a long arm. Be sure your quilt is supported as PaperPrincess mentioned. Hang in there.
#4
Wouldn't you know I would try something that I should not have. I am using a size 14 top-stitch needle. Tried a size 12. Yes, the quilt is well supported, not dragging or anything. Thanks ladies.
#6
Power Poster
Join Date: Mar 2011
Location: Ontario, Canada
Posts: 41,554
I think it is the density of the the 2 cotton batts. Cotton tends to cling to the needle and the 2 batts might be holding the needle up just enough to miss the bobbin thread. It will probably take either a super sharp needle to penetrate quickly or a big enough needle to punch a big enough hole.
#7
Super Member
Join Date: May 2011
Location: Pacific NW
Posts: 9,591
I also think you need to go up a size in your needle. Usually when you increase the bulk and then start getting skipped stitches, a larger needle will be the fix.
p.s. That is an awesome machine. I have one and it's my favorite.
p.s. That is an awesome machine. I have one and it's my favorite.
#8
What sometimes happens is that the needle flexes, causing it not to make a good stitch. That is one reason a heavier needle can help. If you're going too fast, especially with the extra thick quilt sandwich, the needle can be deflected because you're pulling it with the fabric. So slowing down may also help.
Thread
Thread Starter
Forum
Replies
Last Post
blzzrdqueen
Main
39
01-19-2015 12:51 PM
earlylace
Main
10
07-15-2010 01:19 PM
sunnyhope
Main
7
07-24-2009 07:15 AM